This Dell PowerEdge 2800 is a legacy enterprise-class tower server powered by Two Intel Xeon single-core 3.00 GHz processors featuring an 800 MHz Front Side Bus (FSB)and 4-36GB drives in a Raid 5 with one hot spare and another logical drive with 3-146GB drives in a Raid 5 using an integrated PERC Integrated PERC 4e/DiThe Dell PowerEdge 2800 is a legacy enterprise-class tower or rack-mountable server powered by Intel Xeon processors on an 800 MHz front-side bus.
Core Specifications:
Processors: Up to two single-core or dual-core Intel Xeon processors (speeds ranging typically from 2.8 GHz up to 3.8 GHz)
Memory: Maximum of 16GB DDR2 (PC2-3200) ECC Registered memory across 6 slots
Storage / Drive Bays: Up to ten (10) hot-pluggable Ultra320 SCSI hard drive bays (internal backplane supports up to 6 drives natively via integrated controller, expandable)
RAID Controller: Integrated PERC 4e/Di ROMB dual-channel Ultra320 SCSI controller (requires optional 256MB cache DIMM and battery backup unit / BBU)
Expansion Slots:
2 x PCI Express (one x4 lane, one x8 lane)
4 x PCI-X (64-bit/100MHz)
1 x traditional PCI (32-bit)
Networking: Dual embedded Gigabit (10/100/1000) NICs
Power Supply: Dual redundant 930W hot-plug power supplies
Remote Management: Optional DRAC 4/I (Dell Remote Access Controller)
Form Factor: Tower and 5U Rack-mountable configurationsSpecifications this system:Service Tag: JFNTS81
Memory: 10GB (10240 MB) DDR2 (PC2-3200) ECC DDR2
Processors: Two single-core 3.00 GHz Intel Xeon processors featuring an 800 MHz Front Side Bus (FSB))
Storage / Drive Bays: 8 hot-pluggable Ultra320 SCSI hard drive bays
RAID Controller: Integrated PERC 4e/Di ROMB dual-channel Ultra320 SCSI controller with 256MB cache DIMM and battery backup unit / BBU
Logical Drive 0 is a Raid 5 (69360 mb) (69.36 gb)
Ch-0 ID-0 is a Hitachi HUS151436VL3800 (34680 MB)
Ch-0 ID-1 is a Hitachi HUS151436VL3800 (34680 MB)
Ch-0 ID-2 is a Hitachi HUS151436VL3800 (34680 MB)
Ch-0 ID-3 is a Hitachi HUS151436VL3800 (34680 MB) (Hot Spare)Technical Specifications Of theHitachi Ultrastar 15K147 HUS151436VL3800 3.5-inch internal hard disk drive.
Capacity: 36.7 GB
Spindle Speed: 15,000 RPM (15K)
Interface: Ultra320 SCSI (80-pin SCA-2)
Form Factor: 3.5-inch low-profile (1-inch height)
Cache: 16 MB
Series: Ultrastar 15K147Logical Drive 1 is a Raid 5 (279800 MB) (279.8 GB)
Ch-0 ID-4 is a Maxtor ATLAS15K2_146SCA (139900 MB)
Ch-0 ID-8 is a Maxtor ATLAS15K2_146SCA (139900 MB)
Ch-0 ID-9 is a Maxtor ATLAS15K2_146SCA (139900 MB)Technical Specifications Of the Maxtor Atlas 15K II
Key Performance Specifications
Capacity: 146 GB (also referred to as 147 GB)
Rotational Speed: 15,000 RPMBuffer / Cache: 8 MB (Certain SAS variations feature 16 MB)
Interface Types: Ultra320 SCSI (Typically available in 68-pin or 80-pin SCA-2 Hot-Swap configurations depending on the exact prefix/suffix, with some sub-models utilizing Serial Attached SCSI / SAS)
Form Factor: 3.5-inch LFF (Low Profile / Large Form Factor)Remote Management: Optional DRAC 4/I (Dell Remote Access Controller)Ultrium 2 (LTO-2) tape drive: (WHICH IS UNTESTED ON THIS SERVER)
An Ultrium 2 (LTO-2) tape drive is a legacy magnetic tape data storage device offering 200 GB of native capacity (400 GB compressed) per cartridge.
Key Specifications & Performance
Data Transfer Rate: Up to 30–35 MB/sec native (60–70 MB/sec with 2:1 compression).
Interface: Typically utilizes Ultra160 LVD SCSI (68-pin HD D-Sub) connectivity.
Backward Compatibility: Can read and write to first-generation Ultrium 1 tapes (at LTO-1 capacity/speeds).
Form Factor: Available in internal 5.25-inch half-height/full-height units or external standalone enclosures from manufacturers like Dell.USB Ports:
2 - USB 2.0 (Front)
2 - USB 2.0 (Rear)
Expansion Slots:
2 x PCI Express (one x4 lane, one x8 lane)
4 x PCI-X (64-bit/100MHz)
1 x traditional PCI (32-bit)
Networking: 2 Dual embedded Gigabit (10/100/1000) NICs (Rear)
Graphics:
1 VGA (Rear)
1 VGA (Front)
Power Supply: 2 Dual redundant 930W hot-plug power supplies
Serial Port: (Rear)
One integrated standard 9-pin, D-subminiature RS-232 serial port located on the back panel.
Serial Port Specifications:
Connector Type: 9-pin D-sub (DB-9) male connector, DTE configuration.Signal Standard: RS-232.
Quantity: 1 rear port (designated as COM1 or COM2 depending on BIOS/MUX configuration).
Parallel Port Specifications:
One integrated bi-directional standard parallel printer port located on the back I/O panel.
Connector Type: 25-pin D-subminiature female connector (IEEE 1284-compliant).
Modes Supported: Standard (SPP), Enhanced Parallel Port (EPP), and Extended Capabilities Port (ECP), configurable via the system BIOS/CMOS setup utility.
Functionality: Designed for legacy printers, external tape drives, or diagnostic equipment attachments.
PS2 Port:
1 Keyboard
1 Mouse
Condition:
This Dell PowerEdge 2800 is working properly. The RAID functions properly but no OS has been installed. There is a Windows Server license sticker on the server. The Ultrium 2 tape unit was not tested (I do not have tapes to test it with) Cosmetically there are some scratches and slight marks but nothing that stops it from working properly. There is no front Bezel on the server. Please take note, all photos are from the Dell PowerEdge 2800 you will receive.
Included items:
1 Dell PowerEdge 28002 Power CordsTelco Related items:
I am retired and selling off all of my surplus telco gear and equipment so keep checking my other items for other good telco deals with fair pricing.
Warranty/Returns:
30 days warranty on hardware only. Warranty does not cover any software issues. Problems caused by abuse or tampering will not be covered by the warranty. All PCs have been fully tested before shipping out. In the unlikely event that a problem does arise on the hardware within 30 days period, please contact us through e-bay Messages for repair, replacement, or refund.
I offer 30 days to return the item and it must be in the same condition as received complete with all accessories. Buyer pays return shipping unless something was not described accurately.Shipping:Fast Shipping within 24 Business-Hours with 30 Days Warranty
I ship within 24 hours (except weekend or holidays) after receiving full payment. Shipping is ONLY in the lower 48 states and I do not ship to APO or PO boxes. Shipping vendor will be chosen by the seller after the purchase.
Payment:
PayPal Payments - Credit cards and e-check payments are accepted through PayPal.Contact Us:
I guarantee the system I'm selling. If you have any issues, questions or concerns, before and after sale, please feel free to e-mail through messaging; I normally respond within 24 hours. To contact me, go to "Questions and answers about this item" at the bottom of the list and click on "Ask a question". Select the type of question you want to ask and click on "Contact the seller".#310