*New* *Sealed* Cisco C9130AXI-B Wireless Access Point.
The Cisco®Catalyst®9130AX Series Access Points are the next generation of enterprise access points. They are resilient, secure, and intelligent.C9130AXI-E is the Cisco Catalyst 9130AX Series Access Point, internal antennas; Wi-Fi 6; 4x4:4 MIMO, EDomain. *S/N is recorded and hidden for security*
Product DetailsC9130AXI-ESpecification
Software
Catalyst 9130AXI
•Cisco Unified Wireless Network Software Release 8.10.x or later
•Cisco IOS®XE Software Release 16.12.1 with AP Device Pack, or later
Supported wireless LAN controllers
•Cisco Catalyst 9800 Series Wireless Controllers
•Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller
802.11n version 2.0 (and related) capabilities
•4x4 MIMO with four spatial streams
•Maximal Ratio Combining (MRC)
•802.11n and 802.11a/g
•20- and 40-MHz channels
•PHY data rates up to 1.5 Gbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz)
•Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive)
•802.11 Dynamic Frequency Selection (DFS)
•Cyclic Shift Diversity (CSD) support
802.11ac
•8x8 downlink MU-MIMO with eight spatial streams
•MRC
•802.11ac beamforming
•20-, 40-, 80-, and 160-MHz channels
•PHY data rates up to 6.9 Gbps (160 MHz with 5 GHz)
•Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
•802.11 DFS
•CSD support
•WPA3 support
802.11ax
•8x8 uplink/downlink MU-MIMO with eight spatial streams
•Uplink/downlink OFDMA
•TWT
•BSS coloring
•MRC
•802.11ax beamforming
•20-, 40-, 80-, and 160-MHz channels
•PHY data rates up to 10 Gbps (160 MHz with 5 GHz and 20 MHz with 2.4 GHz)
•Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
•802.11 DFS
•CSD support
•WPA3 support
Integrated antenna
•2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth
•5 GHz: Peak gain 6 dBi, internal antenna, omnidirectional in azimuth
Interfaces
•1x 100, 1000, 2500, 5000 Multigigabit Ethernet (RJ-45)–IEEE 802.3bz
•Management console port (RJ-45)
•USB 2.0 at 4.5W (enabled via future software)
Indicators
•Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors
Dimensions (W x L x H)
•Access point (without mounting brackets):
- C9130AXI: 8.9 x 8.9 x 1.88 in. (22.6 x 22.6 x 4.8 cm)
Environmental
Cisco Catalyst 9130AXI
•Nonoperating (storage) temperature: -22°to 158°F (-30°to 70°C)
•Nonoperating (storage) altitude test: 25˚C, 15,000 ft (4600 m)
•Operating temperature: 32°to 122°F (0°to 50°C)
•Operating humidity: 10% to 90% (noncondensing)
•Operating altitude test: 40˚C, 9843 ft (3000 m)
Note: When the ambient operating temperature exceeds 40°C, the access point will shift from 8x8 to 4x4 on the 5 GHz radio, uplink Ethernet will downgrade to 1 Gigabit Ethernet; however, the USB interface will remain enabled.
System memory
•2048 MB DRAM
•1024 MB flash
Available transmit power settings
2.4 GHz
•23 dBm (200 mW)
•20 dBm (100 mW)
•17 dBm (50 mW)
•14 dBm (25 mW)
•11 dBm (12.5 mW)
•8 dBm (6.25 mW)
•5 dBm (3.13 mW)
•2 dBm (1.56 mW)
•-1 dBm (0.79 mW)
•-4 dBm(0.39 mW)
5 GHz
•26 dBm (400 mW)
•23 dBm (200 mW)
•20 dBm (100 mW)
•17 dBm (50 mW)
•14 dBm (25 mW)
•11 dBm (12.5 mW)
•8 dBm (6.25 mW)
•5 dBm (3.13 mW)
•2 dBm (1.56 mW)
•-1 dBm (0.79 mW)
Maximum number of nonoverlapping channels
2.4 GHz
•802.11b/g:
-20 MHz: 3
•802.11n:
- 20 MHz: 3
•802.11ax:
- 20 MHz: 3
5 GHz
•802.11a:
- 20 MHz: 26 FCC, 16 EU
•802.11n:
- 20 MHz: 26 FCC, 16 EU
- 40 MHz: 12 FCC, 7 EU
•802.11ac/ax:
- 20 MHz: 26 FCC, 16 EU
- 40 MHz: 12 FCC, 7 EU
- 80 MHz: 5 FCC, 3 EU
- 160 MHz 2 FCC, 1 EU
Note: This varies by regulatory domain. Refer to the product documentation for specific details for each regulatory domain.
Compliance standards
•Safety:
- IEC 60950-1
- EN 60950-1
- UL 60950-1
- CAN/CSA-C22.2 No. 60950-1
- AS/NZS60950.1
- UL 2043
- Class III equipment
•Emissions:
- CISPR 32 (rev. 2015)
- EN 55032 (rev. 2012/AC:2013)
- EN 55032 (rev. 2015)
- EN61000-3-2 (rev. 2014)
- EN61000-3-3 (rev. 2013)
- KN61000-3-2
- KN61000-3-3
- AS/NZS CISPR 32 Class B (rev. 2015)
- 47 CFR FCC Part 15B
- ICES-003 (rev. 2016 Issue 6, Class B)
- VCCI-CISPR 32
- CNS (rev. 13438)
- KN-32
- QCVN 118:2018/BTTTT
•Immunity:
- CISPR 24 (rev. 2010)
- EN 55024 + AMD 1(rev. 2010)
- EN 55035: 2017
- KN35
•Emissions and immunity:
- EN 301 489-1 (v2.1.1 2017-02)
- EN 301 489-17 (v3.1.1 2017-02)
- QCVN (18:2014)
- QCVN 112:2017/BTTTT
- KN 489-1
- KN 489-17
- EN 60601-1-2:2015
- EN 61000-6-1: 2007
•Radio:
- EN 300 328 (v2.1.1)
- EN 301 893 (v2.1.1)
- AS/NZS 4268 (rev. 2017)
- 47 CFR FCC Part 15C, 15.247, 15.407
- RSP-100
- RSS-GEN
- RSS-247
- China regulations SRRC
- LP0002 (rev 2018.1.10)
- Japan Std. 33a, Std. 66, and Std. 71
•RF safety:
- EN 50385 (rev. Aug 2002)
- ARPANSA
- AS/NZS 2772 (rev. 2016)
- EN 62209-1 (rev. 2016)
- EN 62209-2 (rev. 2010)
- 47 CFR Part 1.1310 and 2.1091
- RSS-102
•IEEE standards:
- IEEE 802.3
- IEEE 802.3ab
- IEEE 802.3af/at
- IEEE 802.11a/b/g/n/ac/ax
- IEEE 802.11h, 802.11d
•Security:
- 802.11i, Wi-Fi Protected Access 2 (WPA2), WPA3
- 802.1X
- Advanced Encryption Standard (AES)
•Extensible Authentication Protocol (EAP) types:
- EAP-Transport Layer Security (TLS)
- EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol (MSCHAP) v2
- Protected EAP (PEAP) v0 or EAP-MSCHAP v2
- EAP-Flexible Authentication via Secure Tunneling (EAP-FAST)
- PEAP v1 or EAP-Generic Token Card (GTC)
- EAP-Subscriber Identity Module (SIM)
