BIGTREETECH MANTA M8P V2.0 Motherboard

32-bit Klipper Ready Control Board for 3D Printers

🔧 Key FeaturesPowerful ARM Cortex-M7

Runs on STM32H723ZET6 550MHz processor for fast, reliable printing performance with Klipper firmware.

Klipper & Marlin Friendly

All-in-one board designed for easy Klipper installation, also compatible with traditional Marlin firmware.

Core Board Compatible

Works seamlessly with CB1 or Raspberry Pi CM4 via BTB connector for a streamlined setup.

Robust Power Design

TPS5450-5A power chip supports DC12/24V input with up to 6A peak output for stable performance.

📐 M8P V2.0MicroprocessorARM Cortex-M7 STM32H723ZET6 550MHzFirmware SupportKlipper / MarlinPower InputDC 12V / 24VCompatible Core BoardsCB1, Raspberry Pi CM4Compatible PrintersVoron, Ender 3, and other 3D printersFeaturesMaterial break detection, BLTouch support, RGB lighting, DFU firmware update📸 Product Images❓ FAQDoes this board support Klipper firmware?

Yes, the Manta M8P is specifically designed to work seamlessly with Klipper firmware, along with traditional Marlin support.

Is a core board (CB1 or CM4) included?

No, this listing is for the motherboard only. A separate core board (CB1 or Raspberry Pi CM4) is required to run Klipper.

What printers is this compatible with?

This board is compatible with a wide range of 3D printers, including Voron and Ender 3 models.

What power input does it support?

It supports DC 12V and 24V power input, common for most 3D printer setups.