Jobolab TMC2208 Stepper Motor Driver

Ultra-Quiet Upgrade for Ender-3, Prusa i3, MKS & RepRap Boards 🔧⚙️

⚠️ Important: This driver requires adequate heatsink cooling and ideally an extra fan. Do not connect/disconnect the motor while powered, and always power via the main supply (not just USB) when measuring voltage.Key FeaturesUltra-Quiet Operation

Up to 1/256 microstepping via MicroPlyer interpolation for smooth, near-silent motor movement.

Flexible Configuration

Supports both Step/Dir interface with CFG pins or UART configuration modes.

Wide Voltage Range

Motor voltage 4.75-36V, logic voltage 3-5V. Handles up to 1.2A RMS / 2.0A peak phase current.

Broad Compatibility

Fits RepRap, MKS, Prusa i3 and Ender-3 style 3D printer controller boards as an upgrade from (CFG Pins or UART)Native MicrostepsUp to 1/256MicroPlyer Microsteps1/256Logic Voltage (VIO)3-5VMotor Voltage (VM)4.75-36VMax Phase Current1.2A RMS, 2.0A PeakCompatibilityRepRap, MKS, Prusa i3, Ender-3 controller boardsCoolingHeatsink included, extra fan recommendedPackage Options5pcs or 10pcsChoosing Your Option5pcs

Includes 5x TMC2208 stepper driver modules with heatsinks.

10pcs

Includes 10x TMC2208 stepper driver modules with heatsinks, ideal for upgrading a full multi-axis printer setup with spares.

Product ImagesFAQDoes this replace an A4988 or DRV8825 driver?

Yes, it's a drop-in upgrade on most RepRap-style controller boards for quieter operation.

Do I need a fan?

An extra fan is strongly recommended to keep the driver cool during extended printing.

Is this compatible with Ender-3 boards?

Yes, it works with Ender-3 and similar Prusa i3/MKS controller boards that support TMC2208 drivers.