3D Printed 120mm PETG Cooling Fan Shroud for NVIDIA Tesla Referral P100 Push-In/Bolt-On
Item Specifics:Type: Fan Shroud / Cooling AdapterCompatible Brand: For NVIDIACompatible Model: Tesla Referral P100Material: PETG (High-Temp)Color: Black but if you need different color feel free to message meFan Size: 120mmStyle: Push-In (screwless) or Bolt-On
Description: Convert your passively cooled NVIDIA Tesla Referral P100 into a quiet, cool-running desktop card! The P100 has no fan of its own and throttles in a normal PC case without forced air. This custom-designed shroud slides onto the rear of the card and mounts a full-size 120mm fan, funneling all of its air straight through the heatsink.
Available in two options. Pick the one that suits your build:
Push-In (Screwless): no screws, no tools. The fan simply pushes into a tapered socket and wedges firmly in place. Finger notches let you pop it back out in seconds.
Bolt-On: a solid 5mm mounting plate with 4 holes on the standard 120mm fan pattern (105mm), for a permanent, rattle-free install. Use M4 bolts and nuts, or rubber anti-vibration mounts for the quietest setup. (Standard self-tapping fan screws are too small for these holes.)Key Features
Premium PETG Construction: Unlike cheap PLA prints that warp and sag inside a hot PC case, this shroud is printed in high-quality PETG. It has excellent heat resistance (up to 230°C 446°F), superior impact strength, and long-term durability through constant heating and cooling.
There is the option for a Static Pressure Brushless Fan: To keep the card cool under high load and quiet. Plug it into a motherboard fan header (the P100 has none).
Snug, Sealed Fit: The collar slides over the end of the card (37.0 x 98.5mm inside, 20mm deep), so the air goes through the card instead of leaking around it. A built-in channel leaves room for the power cable.
Sleek Aesthetic: Printed in a clean [matte black] finish that looks great in any custom rig.Compatibility: Designed for the NVIDIA Tesla Referral P100. Other passive Tesla Referral cards may fit if the rear end of the card slides into a 37.0 x 98.5mm opening. Please measure your card before purchasing. A dimensioned drawing of both options is in the photos.
Specifications
Push-In: 127.3 x 127.3 x 55mm, fits any 120 x 120 x 25mm fanBolt-On: 122 x 122 x 55mm, 4 x 4.5mm holes on 105 x 105mmMaterial: PETGWhat's Included
1x 3D-Printed PETG 120mm Fan Shroud for NVIDIA Tesla Referral P100, in your choice of Push-In or Bolt-On (Note: Fans, GPU, and mounting hardware are not included).